The AC-powered, hardwired Kidde i12040 ionization smoke alarm is designed to protect you and your family from the dangers of smoke and fire. This smoke alarm's trademarked hush feature allows you to silence nuisance alarms, while an indicator LED and test feature let you easily confirm that the alarm is working. This wire-in smoke detector also has a battery-backup feature (with included 9-volt battery).Keep your family safe with this hardwired Kidde i12040 smoke alarm.
The Kidde i12040 smoke alarm offers a tamper-resistant feature to deter vandalism or theft and a smart interconnect system that connects with up to 24 Kidde devices--including other smoke alarms plus carbon monoxide and heat alarms. The battery-backup feature (9-volt battery included) provides protection even during power outages when many CO incidences occur. It has a large mounting base that helps protect surface paint from dirt and covers imperfections, and its pre-stripped wiring harness has an easy-off cap and tinned strands to increase conductivity.
By pressing the hush button, you can easily and safely silence nuisance alarms caused by non-emergency situations, such as overcooked dinners. This feature desensitizes the alarm for approximately seven minutes. During this time, the alarm chirps every 30 to 40 seconds. If the smoke is too dense, the hush feature is overridden and the alarm still sounds, and the alarm automatically resets at the end of the seven minutes. This convenient safety measure eliminates the temptation to remove the alarm's battery, which creates an unsafe situation.
The Kidde i12040 smoke alarm uses ionization sensing technology, which may detect invisible fire particles (associated with flaming fires) sooner than photoelectric alarms. Photoelectric sensing alarms may detect visible particles (associated with smoldering fires) sooner than ionization alarms. Kidde recommends that both ionization and photoelectric smoke alarms be installed to insure maximum detection.
One Kidde i12040 120V AC wire-in smoke alarm, one 9-volt battery, and operating and installation instructions.
The KN-COSM-IBA combines a Carbon Monoxide and Ionization Smoke Alarm, providing two important safety devices in a single unit. This alarm includes a voice warning system that helps eliminate confusion, as it tells you if its detected fire or carbon monoxide, or even if it needs a new battery. This alarm has 2 AA battery backup, which protects you and your family — even during a power outage when many incidences occur. The alarm also allows you to easily silence nuisance alarms using its convenient Smart Hush feature.
This talking combo alarm is powered by your home's electricity and can interconnect with other smoke alarms in your home. Experts recommend interconnected alarms, because when one sounds, they all sound, providing an early warning against fire by dramatically increasing your ability to hear an alarm anywhere in your home, regardless of where the fire starts.Provides the recommended protection of an interconnected system. When one alarm goes off, they all do (view larger).
The Kidde Combination Carbon Monoxide & Smoke Alarm includes a voice warning system that eliminates confusion and clearly warns you and your family of a smoke or carbon monoxide danger, or if your battery is in need of replacement or your alarm is in hush mode.
Fire: The red LED will flash and be accompanied by three long alarm beeps followed by a verbal warning message "Fire! Fire!" The alarm will repeat pattern until smoke is eliminated.
Carbon Monoxide: Four short alarm beeps followed by a verbal warning "Warning! Carbon Monoxide!" This continues until the unit is reset or CO is eliminated.
Low Battery: One chirp followed by warning "Low Battery" The red LED light will flash. This pattern will continue every minute for the first hour. After the first hour the red LED light will flash once every minute accompanied by the chirp sound. The low battery warning will only sound once every fifteen minutes.
Voice Hush Indication: "Hush Activated" and "Hush Cancelled" voice announcement.
Peak Level Memory: If the alarm had detected a CO level of 100ppm or higher when the Test/Reset button is pressed, the unit will announce "Carbon Monoxide Previously Detected" to warn of the CO incident.
Fire and consumer experts recommend interconnected alarms for added protection. According to the National Fire Protection Association (NFPA), most Americans feel they are more at risk of being a victim of a tornado than of a house fire. Actually the opposite is true. Fires are more common than any other disaster that strikes a family at home, and can become deadly in minutes.
You have on average less than three minutes from the time you hear a smoke alarm to escape a fire. The sooner you hear an alarm, the sooner you can get out safely. Smoke alarms that link together so that when one goes off, they all go off, are called interconnected alarms. These alarms provide more warnings in more places, giving your family more time to escape a house fire. Houses built after 1993 are required by building codes to have interconnected alarms that are wired into their electrical system.
By pressing the Hush button, you can easily and safely silence nuisance alarms caused by non-emergency situations, such as overcooked dinners.
This feature desensitizes the alarm for approximately ten minutes. If the smoke is not too dense, the alarm will silence immediately, the unit will verbally announce "Hush Mode Activated," and the green LED will flash every 2 seconds for approximately 10 minutes.
The alarm's AA battery backup provides continuous protection, even during power outages. Because this alarm only helps protect you if it's working, this unit features a red LED that flashes every 30 to 40 seconds to indicate that it is operating correctly. For additional peace of mind, the alarm also contains a test/reset button that enables you to periodically test its circuitry and horn.
If any form of battery failure is detected the red LED light will flash and the unit will "chirp" one time, followed by the warning message "Low Battery." This cycle will occur once every minute, and will continue for at least seven days.
Ten years after initial power up, this unit will "chirp"every 30 seconds. This is an "operational end of life" feature which will indicate that it is time to replace the alarm. UL 2034, the independent standard applicable to CO alarms, requires CO alarms to have an end of life warning. This requirement went into effect in March 2007, meaning any CO alarm manufactured after April 2007 with a UL listing must have this feature. Most states that require CO alarms in residential dwellings mandate that the alarm meet the UL 2034 standard.
The unit measures just 5.75 inches in diameter and 1.7 inches deep, and it features a neutral, white finish. It includes tamper resist features to deter vandalism or theft. This combination smoke/CO alarm is UL listed, so you can be confident of its quality, and it is backed by a 10-year limited warranty.
Renowned for global leadership in fire detection and suppression, Kidde provides solutions ranging from portable fire extinguishers to advanced industrial controls such as flame detection and explosion suppression systems. Kidde is a UTC Fire & Security brand, with a history that's rich with innovations, from the patent of the Chubb Detector Lock in 1818 to the development of the world's first wireless networked smoke detectors in 2004.
Combination smoke and carbon monoxide alarm with mounting bracket and mounting hardware, quick-connect wiring harness, two AA batteries, a 10-year limited warranty and a bilingual (English/Spanish) user's manual.
How to replace a smoke alarm detector can be installed by you......yes you. There's a few how to steps to complete, when replacing a smoke alarm detector, bu...